The grain bin gazebo is starting to come together. I as usual did not watch any videos, ask anyone and spent 10 minutes looking at pictures on the internet as a precursor to building said gazebo. The guy I purchased the parts from told me it was the bottom 10 feet of a 20 foot grain bin, he gave me two tubs of bolts and nuts, four floor anchors, a pile of roof anchors, a door, the roof parts and central roof ring. Supposedly the only thing missing was the vent cap for the roof. This was promptly unloaded and ignored for two years.
Well, let me say that it is definitely the bottom half due to how heavy the pieces are. We did not get enough pieces to go to ten feet, only eight feet and if we put up a full ring for the roof then you would have hit your head every time you went in and out of the gazebo. We could have cut one of the upper panels but then I was afraid it would weaken the roof. The bottom line was after talking with the boss, wife, we opened up enough of the gazebo to have a full six pieces to go around the entire top and to get the gazebo sides over ten feet into the air. It’s actually about ten feet six inches high now at the walls with the roof I think it will be another 4-5 feet higher.
This morning I decided to do a little research on how to put the roof together. Yeah, I was better off not knowing. They used a crane, built the roof and then stood on the ground and proceeded to add a row of panels and lift up the entire grain bin as they built it. No ladders needed! The only drawback for me is that I don’t own a crane. Instead we used the trusty Kubota with the forks on it, a chain and some Vice-grips to hold the chain at the far end of the forks. This worked to get the third and fourth row in place. The fourth row was the worst. We ended up having to drill out three holes that we just could not get lined up, they were off by about 1/8” and the entire rest of the panel was already bolted together.
Mr Rainman came over Friday morning and we got the three panels up on the high back wall. It was a battle to get them bent into shape, another problem with not putting them back on in the exact order they were removed. I put up the last three rings myself with the Kubota being my trusty partner. At no point did I fall. I did tear my finger away from one of my fingernails enough to make it bleed and discovered a metal sliver in my finger this morning. The bolts had to be put on between the panel and the wooden support posts and this was an incredibly tight fit. Putting the posts 1/2” from the metal and then adding bolts meant some of the bolts are touching the posts. This is a good thing when I screwed in the lag bolt anchors.
The trusty Kubota is not going to be able to lift the center ring for the roof. It will only lift something about eight feet into the air. I am going to bolt two ten foot 6×6 posts to the upright frame of the forks resting each one on a fork. But first I am going to get a stout wooden pallet. This will let me put a diagonal support out to the front of the forks. I will then build a small open box with 45 degree supports at the top for the posts. This is where the roof ring will sit. I can then lift it up and get it centered with the tractor and then assemble the roof. I think this will work. No, I am confident this will work!
I just have to figure out how the roof support pieces go onto the sides…
Stewart Creek Somethings 