Yesterday, I made sure and put a strap across the lower portion of the entire back gate on the stock trailer before leaving moving the trailer. I kept it backed up to the corral while I installed it. I am still not sure it is necessary but after the previous evening I am taking no chances. I headed out and got about halfway down the driveway when I realized I had forgotten the cut sheets and had to go back. The puppy was going to spend the day with grandma so he got to go with me. I needed to stop at the feed store but they let you take dogs inside and he is still getting socialized to all things different so it will be good for him. When I got to the college I warned them that the cows were crazy. Unbeknownst to me, the middle divider gate had not gotten latched against the back wall so at some point when I was making a turn it flopped into place and the latch actually worked. So the three cows were trapped in the front of the trailer when I stopped. The bad part about this is I have to go into the trailer to open it. I did and luckily the cows ran past me and into the college pen system. The cut sheets were handed off and only one of them still had an ear tag. The damn cows are worse at ripping them off than the sheep are.
Milo and I shopped for some cable and eyelets for the Gazebo. We want to install a string of light inside with a dimmer and light sensing system. I have the lights and control plug ordered and they should be here next week. He does great with doors, people and confusion, a real trooper. It helps that he is calm and cute. After he was dropped off at Grandma’s I headed home to install the cable.
Nope, I let the sheep out of the barn and promptly got the tractor to pick up all the lumber needed to fix the corral. I am unsure if it was out of frustration and the desire to not repeat the experience or just leftover anger at having to chase the cows for an hour and a half! I picked up the last of the 2×8 rough cut tamarack boards I had purchased years ago for building Alcatraz. We had them and some 1x12x16’ boards stored in Alcatraz on the old concrete granary foundation. I need to dig a little more dirt out of the foundation. The damn rockchucks have been digging and living under the board pile. So they kicked up dirt and caused a couple of the bottom boards to rot. But for the most part the lumber is in good enough shape to fix the corral. The boards on top are pretty twisted but a heavy duty construction anchor bolt straightens that right out. I used the rest of the lag screws leftover from the Gazebo. I had bought a bucket of 500, half were used on the Gazebo and a quarter were used on the corral. I had a box of 50 six inch lags that I had to also use on the corral as some of the locations needed a longer screw to get to the good wood. I was only going to do a little bit of the corral but the longer I did it the further I needed to get to completion. I used every single board I had and the last one had to be spliced together, there was just enough.
Once I had the corral walls elevated it was fairly obvious that three of the gates would need to be raised. I am going to use the 1×12 boards for this. I will be sandwiching them on each side of the gate to form two uprights then bolting another board across the top. I decided that I needed to use bolts instead of lags and I did not have 32 5.5” lag bolts and assorted accoutrements. I went back to the hardware store to get all of the needed pieces but it was already evening and time for chores again. I put away all of my tools and finished the evening chores.
When I was taking pictures of the corral I realized that the day was quite stunning and took a few extra pictures. I love the old grain auger and am always trying different pictures. I also made it a point to go out and take a picture of the crazy psycho cow that must go to the abattoir. He is not getting out of it this time, #34 I have your number!
Stewart Creek Somethings 