It doesn’t seem like I got a lot done over the weekend without Mr Rainman helping but the wiring I could do without cutting out the bathroom floor is done! I also spent a lot of time looking at problems and how to get around them.
Today, Mr Rainman came out and we started with him just cutting boards for a couple of hours. I was able to get the chimney wall all covered so that it can now have plywood applied. I needed to get the boards to stick out past the chimney. I was going to just line the whole wall with 2×6 but Annmarie told me that was overkill. So I lined them up every other instead. Of course I had them up for about 30 minutes before I realized that I had covered up the recessed shelving space. So I had to cut out the recessed areas.
We also had to trim some board at the ceiling height, it was going to throw off the plywood. He cut all the boards for the pocket door rough opening but we had to shim one side to get it square, level and perpendicular to the wall. We had three more places where we had to put fill in 2×4 so there was something to attach the plywood to in the corners.
Mr Rainman cut out the floor and we realized that they had cut the floor joist eons ago to install the toilet. We suspect it was the original. Unfortunately, they did not just box it out so we ended up putting in several support pieces so we can install the new subfloor.
I was crowing about how awesome we were doing when I remembered I had to crawl under the house and move two wires into the walls, not just next to them. The underside of the house is dirty and there are a gazillion spiderwebs that kept getting in my face. I had to crawl around on my belly to access the wires.
It was at this point that it dawned on me that we had not yet run power from the breaker box to the bathroom for the new overhead built in heater. I had Mr Rainman feed me the wire and I crawled about halfway when Annmarie came home and said she had a student meeting. I needed to kill all power to the house. When turning off the water or power always check in with your spouse. So I had an excuse to not finish the power install today. Plus, you never know when you are going to hit a snag and the power may need to stay off all night!
I had forgotten that I had tripped breaker #29 to rewire the two outlets in the living room. The cables had to be moved to fix the floor. Annmarie could not turn on the overhead living room light so I had to go fix the outlet so I could turn the power back on.
The pocket door kit was delivered this evening! It is still in the box and will need to be trimmed to fit our 29.75” door. We are going to reuse the original door as our pocket door. I am going to install the frame without the floor roughed in. This will let me move the tile under the door pathway. I am about three inches too short on the door for it to not have a gap at the floor. I will build up the floor about 1.25” and I think I can lower the door about an inch, so now I only have to add on 1” of wood at the top of the door to make it work. The patch job will be hidden at the top of the channel and I doubt anyone will notice.
I tried to get the baby chicks to come out of their area in the coop yesterday. I opened up the door and propped it open so they could intermingle with the older hens. They failed at their assignment. So today I tossed them all out, shut the door so they could not go back and put them in the area below the nesting boxes. I did use the heat lamp on that side of the coop for just this reason. They are only two months old and do have all their feathers but they are not big chickens. This should force more interaction between them and the adults.
Stewart Creek Somethings 