It seems like every project is two steps forward and one back. I was able to work on the machine shed ridge line install yesterday. I had found some small two foot peak sections somewhere on the farm but they were not enough to cover the entire ridge line. I purchased some trough metal that I turned upside down and used as ridge cap. It was at a close out and I only paid about $8/piece. I was trying to use up my leftover roofing screws from the barn. The only problem is I ran out with only 27 left to be installed. They are oversized as I was reusing metal tin and needed a larger size to go through the existing holes. This meant I had to drill a pilot hole first. I drilled those 27 holes before climbing down from the roof and of course could not find a #14 screw anywhere in town. I had some #10 but they were red! I ended up ordering some and they should be here this week. Luckily, I ran out of screws as the sun was heating the roof up to unbearable temperatures but I kept trying to get it all done so I would not have to climb back up on the roof. I ended up going to town to get some oak, some trim for the cook stones enclosure, sheep and lamb pellets and some bolts to fix the gazebo door.
I had enough time to repair the gazebo door, cut off the door handle bolt and install a new one. I still ended up beating and bending the door into submission to get it on. Our original plan was to use the door to get to the grill outside after I built a lean to on the back of the gazebo. Nope, not going to happen. That door will be staying shut, it took a hammer and a couple of minutes to get it shut the first time. The grill will be going inside the gazebo. I just have to figure out where the grill is going to go as I need to run the power to that spot.
Today I took the second repaired cattle feeder out into the alleyway and got it ready for a large bale. I dumped some more scraps onto the burn pile. All the burn piles are starting to grow pretty fast now as we continue cleaning up. I got the weight box for the tractor and took it over to the machine shop so it could be repaired. The supports keep bending from the weight of all the metal horse shoes. I beat on the three point supports with an eight pound sledge hammer then proceeded to weld some supports on all three attachment points. I am hopeful that it will keep them from bending now during the winter use. I am still welding pretty roughly but it is holding and that is the main purpose for my welding skills.
I took 1000# of sheep and lamb feed out to the barn. We are storing the sweet feed in the large grainbin we have in the momma/baby area. I put 450# in it today and I am pretty sure I can fit another 1000# in it. The lamb creep feed gate is up and we are now feeding the lambs where the mommas cannot reach. This should hopefully help the mommas not slough so much weight. I took all of the leftover feed bags and net wrapping and bagged it all up and took it out of the barn. Annmarie had been complaining about there being no box knives out in the barn. I found two knives in the trash bin, some lamb nutrient mix and some hoof treatment powder. So now we know where all of that is located.
Annmarie really wants the house number holder completed so I started welding that project today. I am a mediocre welder so hopefully this turns out well. I got the rough frame welded today but had to let it cool off before I could work on it some more. Tomorrow I will grind it smooth and try and make it pretty. Hopefully the tile will still slide into the end. We will know tomorrow!
The porch lights went out for the third time! This is after I wired the new ones in. I took the main one down again, took it all apart and used a voltmeter this time to check everything and the switch. It turns out that it was the cheap porch light bulbs. They had blown up with all of our power losses. I bought LED this time!
Stewart Creek Somethings 