Irrigation planning

Annmarie wanted me to make some progress on the field water set up. I always get busy in the spring with hay and seem to run out of time. I purchased a 4×6 pressure treated board a few months ago but never used it. My DeWalt electric grease gun came in on Friday and I loaded it with grease. I still needed fuel then I could “work” with my new mini excavator. It is still sitting on the trailer. Instead I was good and went to work on the irrigation. The first thing that needed done was to stabilize the two supports that go across the concrete weir. I had made these years ago and just screwed them together but over the years they have started to spread apart. They are not pressure treated but hanging out over the concrete they just don’t get wet enough to rot. So I took some 12” all-thread pieces and drilled three holes in each one and installed a bolt the entire width and cranked that down as tight as it would go. Once I had those placed over the concrete and no dirt touching on each side I started in on the pump support. It only needs to be on three sides so I cut each joint off halfway so I could overlap the boards and bolt them together with carriage bolts. I left the carriage bolts sticking up as I may use them to secure the wiring or hang the water pipe from in the spring. I am not sure yet if they will be useful but they are not hurting anything by sticking up now.

I did not have any pressure treated boards to make the upright and roof so I went to Tum-a-Lum and bought the only farmer’s pack of bent, twisted and broken pressure treated 2×8”x12’. I was able to buy 11 boards for $100. Anyone who has bought boards will know that is a great price. I was able to just physically tear one board in half and use it for the roof support. I had some old metal roofing and used that on the tall side and on the roof. This should keep the pump fairly dry at all times. I may install sides if necessary in the spring. The bush needs a trim as it has 1” thorns on it and they are very sharp! The entire thing cost us $130 to install and build. I will use those leftover boards for something else. I did pick up fuel for the mini-excavator!

I think I need to install a 6’ gate down by the apple tree and then make about 40’ of fence movable so that I can get the mini-excavator to both sides of the water retention pond for irrigation. I was looking at the fence and I don’t think it will be that hard. I need to repair my weight box for the tractor so that I can move the big bales. It needs some welding and steel reinforcement. That is on my list along with haying and mini-excavator for my vacation coming up. I am gonna live it up!

Predators 30/ Farm 3

It’s been a long week, I have been keeping the Ring camera open at night while we are watching TV so I can spot the predators killing our chickens, cats and eating our eggs. I had a few issues with this as always. I don’t particularly want to get sprayed by a skunk and our back door is right next to the cat feeding area so if I barge out there guns-a-blazing I am gonna get a face full of spray. This makes it imperative that I actually identify my victim prior to opening the door so I know what to expect. I spotted a raccoon right after it got dark on Tuesday night. I crept out to the back porch and silently as possible racked the action on my pistol to not scare the raccoon away. It really had nothing to fear. I dry fired the pistol as I had not cycled the hammer by gently racking the pistol. I cycled it again quickly but the raccoon was no fool and was beating feet as fast as possible and I never got off a good shot again. It was right there! I dropped the magazine and cleared the chamber when I went back inside the house.

Thirty minutes later I spot a smaller cat eating. As I keep looking at it the cat has a funny shape and color. Turns out it was a huge possum! I do the sneak approach and same thing happens. Luckily, they are a lot slower than a raccoon and I was able to dispatch it. It was headed to the berry patch. Thirty minutes later another huge possum shows up and this one tries to get under the old house. Again, damn pistol dry fired first round. At this point I realize I may need to actually clean the pistol. Honestly, I am unsure of the last time I did it.

But I decided that readiness was going to out trump safety and just kept one in the chamber and turned the safety on. It is hidden so it is not easily accessible. An hour later the raccoon came back and I was able to get off two good shots then had to chase it up the dry creek bed before finally putting it down. I had just counted my chickens before it got dark. The predators have killed over a dozen and they killed our two matching pairs of silkie chickens! Both the grey ones and the brown ones, rooster and hen. Those were the coolest of the new chickens. I think I have around 24 chickens now. This is a stupid problem! We know there is at least one skunk and two more raccoons around the place but I have not seen them on the Ring camera this week. So I will keep watching every night. The four new adult fixed cats we got are still hanging out around the back porch. I don’t know if they will be a deterrent to the predators or not.

Annmarie has been getting ready for her new loom. She took her old project off the inside loom so that we could send that loom home with Sarah. I am told that the rest of the industrial loom is coming up next week and then we can start working on getting it assembled. We are going to use the runner to cover our safes in the living room or else to cover the old wooden fridge in the hallway. It is made out of wool. She tells me she can see all of the mistakes but I cannot.

I was able to finally pickup carcasses to take them up onto the hillside for disposal this weekend. They do smell quite a bit after a few days but the important part is that I discovered one of our neighbors had upgraded and replaced about 50% of the fence that is along our adjoining property lines! This is way cool as it was one that was on our sooner than later upgrade but that was five years from now.

Sheep moved

Well it was time to get the sheep moved over to Hermiston for the next two months. They eat down a lot of very green grass and that means that the spring hay cutting is premium and the property gets fertilized by the sheep also. Annmarie helped me sort the sheep into three groups, ewe lambs, ewes & rams and whethers. Our plan was to pull the three rams off the ewes but they kept trying to breed the ewes in the barn so we figured they were not done. This is going to spread out our lambing season but we have to check on the herd twice daily during the winter to lock them up at night and let them out in the morning. We need more lambs! I am hoping these whethers sell for $200/each at auction when we take them in December.

I am a firm believer that prior to a couple paying for marriage counseling they should have to sort sheep. I have narrowed it down to sheep as cows can be dangerous if not done correctly and you can mostly just get mowed over by a sheep. The couple in “animal therapy”are not allowed to quit until the job is done, regardless of how long it takes or how hard it gets. No one is allowed to walk off either, both parties have to stay within speaking range of each other. Annmarie and I did get the sheep sorted and it only took a couple of hours. We decided on three herds. The whethers will go to the small field in Hermiston, the ewes/rams to the large field and the ewe lambs will stay on the farm and go up with the breeding cows.

There are virtually no flowers this late in the season except for our Jerusalem artichokes, they just bloomed this last week. When it gets cold I will need to dig them up. We have started to feed the bees again in earnest. I will need to pull the hive from field 1 this next weekend and get the gutters on the bee enclosure.

I still have not played with the new mini excavator. I ordered a DeWalt grease gun. It was time to get one and then I can grease up the entire machine, check all the bolts and nuts and fill up the gas and give it a whirl. I have vacation in ten days so I will be using it then. I have to cut hay and bale it during my vacation also. My next weekend is for working on the greenhouse. I have had three panels blow out already. I need to watch those videos and see what I can caulk to hold the panels in place. Because the metal clips are not working by themselves.

I was able to get all the sheep moved in two trips on Sunday. I had to get the electric fence working in the small field and get the temporary fence installed in the larger field. We only have 25 ewes and we want to get to 40-45. I would love to take 60 lambs to market every year. I think I need to look at the diesel pickup and check the power and lights to the trailer plug. I don’t think they are working. I will add this to my list.