Stewart Creek Somethings

I have embraced the mechanic option out of necessity. All of my hay equipment is out of Italy and no one around here will work on it. So I have to fix it myself if I want to use it. I had to fix the sickle bar mower before I could go out and cut the first batch of hay on our place. Luckily, when I placed the order for parts I ordered everything I thought I would need except for one bolt that was going to have to come from Italy. That single bolt would have cost me $50. I figured I could find a bolt that would work for less than that.

I got the end of the sickle bar torn off and the new parts on. I was able to find a workable bolt to substitute for the Italy special. I went out and started to cut all of field #1. About halfway through it the mower stopped working. I had lost a bolt on the bar itself and one of the retainers had spun around. I drove back, replaced the bolt (I had purchased spares) and then tightened all of the bolts on the entire sickle bar and regreased everything. I went out and finished cutting the entire field. I did have to work past sundown. I did not want to come back and cut the last section in the morning. It would screw with the drying rate. When I got back I did notice that the Italy special replacement bolt had already bent. I am going to have to tear that fin off and beat on it with a very large hammer. I think I have gotten a sharper angle bent into it than it should have over the years of just normal usage. It needs some hammer therapy on the anvil to set it straight, literally! I know there is a second bolt available so I will replace the bent one when it is reassembled.

I found two batches of pheasant chicks out in the field when I was cutting, both were in the far middle of the pasture. I had to work hard not to run them over or cut them up with the bar. I managed to not hurt a single one.

I went out the next afternoon and turned and rowed the hay. So some of it had just barely had 24 hours or less since it was first cut. It was not super hot out but the hay was drying out fast. I rowed it with the power rake but again by the time I was done with the rake I had broken 8 tines! It was set too low and I had a lot of old tines on it. I do not believe there are very many old tines left. I had to go past dark again before it was completed. The hay was pretty dry so I knew I would be baling the next day. I will now need to repair this piece of equipment before it can be used again. I have instituted a repair personal priority system. The order in which the pieces of equipment are going to be needed are the order in which they are repaired. So the sickle bar mower first, then the powered rake then the baler.

We have our three yearling calves in the orchard near the houses and driveway. We are just tired of the butcher calves just being crazy because they never have to deal with humans until we run them into the pen to be killed. We are hoping that by us being able to talk to them and them being around us they will calm down. They are a little calmer currently than last year. The real problem is that Annmarie thinks we missed a testicle when we banded the calves. So far we have not ran them into the chute for a definitive grab/inspection. We are usually pretty careful about the cows when they are getting banded. Time will tell on this issue.