Well the granary situation has improved dramatically. It was going to cost almost $700 in sheet metal and welding wire to make another 5x5x5’ bin and one of the nephews sent me a link for a local person selling two large upright bins! I did not need both of them despite their willingness to sell me both. So for $750 they delivered it to the house on Friday. I had cleared a spot and dropped a bunch of gravel in place but after looking at the container I think I need to level the area and then drill five holes in the ground, add some wire and fill them up with concrete. I can take a piece of all thread and put it into the concrete when it’s wet. I don’t think I will try and line up the holes with the grain bin. I will just weld some plates and bolt them in place.
I also managed to get some paint sprayed on the finished bin I repaired and got the slider door installed. Of course when I used a chain to roll the bin I bent the brand new door. I crawled inside and beat it back into shape with a hammer. It works now, it’s a little stiff but that is not a bad thing as I want opening the door to be an intentional act. It looks like the bin has a ladder built into its side so someone can climb the bin and open the top when filling it. This is a good thing as long as you are not scared of heights. I will have to get the cap removal process down before we lift it into the air. I would like to stand on the ground while learning, not holding onto the ladder with one arm 25’ into the air while fighting the lid with the other.
The Naked Gardener called on Thursday to say that he thinks his field is ready to cut again. I swung by on Friday and he is right, it is ready. So I spent most of the day Friday tearing the baler apart. I figured out that it is a lot easier to work on if you remove the front arms and some extra pieces. It took about an hour to disassemble the front but it was a lot easier getting to everything else. There was one guide piece I could not remove but I just worked around it. I was going to have to grind the nuts off and it is just not necessary as I am not replacing it. I replaced about 1/3 of the pickups and tubes. Anything that was bent got tossed in the trash. I have about an hour left to get the races lined up and then I can spend another hour putting the front all back together. I also need to replace a hydraulic hose. The entire thing is covered in hydraulic fluid. It needs a wash down.
Unfortunately, I am on a timer now. I went over and cut the field this evening. So the new tractor “Juicy” has had a flat tire for two weeks in the upper field, I had to go up and remove the tire tonight so it can be fixed. The hay turner is on the back and it needs about 45 minutes of TLC before I can go turn the hay. Once that is done then I will need to spend three hours with the baler to get it up and running so I can bale the hay!
I also will need to install the two new gates on our stairs to prevent the grandchild from crawling up and falling down from the bottom or falling down the stairs from the top. This is what happens when your grandparents work in the hospital and see bad stuff all the time.
The new chickens area settling in nicely. All of them are staying out of the yard which is good for them as being a play toy for the dog tends to an eventual slow death.
We now have three kittens living under the old house porch. We have installed a temporary fence to keep Mouse away from them as he is a definite kitten killer. He only comes on weekends with the kids. Of course, the kittens don’t know this so they were going through the fence as they are now starting to become very active. So we now have a plastic chicken netting zip tied to the fence so the kittens cannot get through the fence. Milo likes the kittens so we will work on socializing him to them. He still does not like their mother and barks at her whenever he sees her.
Stewart Creek Somethings 